Preparation; Assembling The Mains Adapter; Charging The Device; Attaching The Base Unit To The Helmet - Silvercrest SMFB 2.1 A1 Bedienungsanleitung

Preparation

Assembling the mains adapter

Assemble the mains adapter
1) Push the contacts into the mains adapter
page, until they click into place.
2) If you want to the remove the contacts from the mains adapter
the surface labelled "PRESS" and slide the contacts upwards.

Charging the device

Before you can use the device it must be charged.
3) Connect the mains adapter
4) Open the protective cover on the main unit and insert the micro USB plug
into the micro USB socket
5) Connect the mains adapter
mains adapter
mains adapter
lights up red.
As soon as the device is charged, the red control lamp
around 2 hours). The green LED on the mains adapter
mains adapter

Attaching the base unit to the helmet

Install the base unit (main unit with microphone
helmet (see Fig. 1):
1) Attach the main unit to the socket plate
2) Secure the fastening plate
the screws
3) The two screws
to the helmet. The fastening plate
the outside of the helmet. The microphone
padding and the outer shell of the helmet between the main unit and the
fastening plate
4) Then tighten the two screws
be attached fi rmly to the helmet!
SMFB 2.1 A1
, if required:
13
to the charger cable
13
on the main unit.
4
to a mains power socket. As soon as the
13
is connected to a mains power socket, the LED on the
13
lights up green. The control lamp
13
is disconnected from the mains.
13
to the rear side of the socket plate
10
(loosely to begin with).
26
need to be loose enough for the base unit to be attached
26
10
.
10
using the Allen key
26
, as shown on the fold-out
13
.
16
on the main unit
7
goes off (after
7
stays lit until the
13
and speakers
12
.
11
is on the inside and the main unit on
points forwards. Clamp the
12
. The base unit must
24
GB
IE
, press
13
14
) in the
9
with
11
9