Specifications; Double Insulation - Makita 4131 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Lever
1-2. Depth guide
2-1. Cutting line
3-1. Switch trigger
3-2. Lock-off button
4-1. Dust cover
4-2. Knob
5-1. Hex wrench
5-2. Shaft lock
6-1. Hex socket head bolt

SPECIFICATIONS

Max. cutting capacity
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･

DOUBLE INSULATION

･
Pay attention! It may become too hot.
･
Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2012/19/EU on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting in mild steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
Explanation of general view
6-2. Outer flange
6-3. Carbide-tipped saw blade
6-4. Inner flange
7-1. Slot
7-2. Rib
8-1. Rip fence (Guide rule)
8-2. Screw
9-1. Carbide-tipped saw blade
9-2. Workpiece
10-1. Sight window
Model
Blade diameter
-1
)
Overall length
Net weight
Safety class
with household
equipment
environmentally
END209-4
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
waste
Vibration
The vibration
determined according to EN60745:
and its
Work mode : cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
compatible
measured in accordance with the standard test
method and may be used for comparing one tool
ENE022-1
with another.
The declared vibration emission value may also be
•
ENF002-2
used in a preliminary assessment of exposure.
3
10-2. Workpiece
11-1. Retracting lever
12-1. Sight window
13-1. Dust cover
13-2. Knob
14-1. Limit mark
15-1. Screwdriver
15-2. Brush holder cap
4131
185 mm
63 mm
3,500
358 mm
5.1 kg
/II
A-weighted noise level
) : 89 dB(A)
pA
) : 100 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 2.5 m/s
h,M
2
ENG905-1
determined
ENG900-1
vector sum)
2
or less
ENG901-1