Assembly, Connection And Commissioning; A) Attaching The Standing Base; B) Inserting/Changing The Remote Control Batteries; C) Screen Connection And Commissioning - Conrad 75 20 16 Bedienungsanleitung

7. Assembly, Connection and Commissioning

When setting up / installing the device, make sure the connecti-
on cables are not squeezed or damaged by sharp edges.
The screen's mounting base may be attached stationarily. It is
equipped with three mounting holes in the bottom. Make sure you
do not damage any cables or power lines when drilling holes in
the wall or fastening screws.
All system components are only approved for operation in dry
indoor rooms.

a) Attaching the Standing Base

If not done at delivery, mount the standing
base on the screen.
b)Inserting/Changing the Batteries of the Remote Control
• Open the battery compartment of the remote control.
• If necessary remove the used batteries.
• Insert two 1.5V micro-batteries (AAA) with correct polarity.
• Close the battery compartment by replacing the battery compartment lid.

c) Screen Connection and Commissioning

• Connect the low voltage plug of the included mains adapter to the "jack for
12V/DC voltage supply (10).
• If required, connect the "VIDEO Input" (13) to, e.g., a surveillance camera.
• If required, connect the "S-VIDEO Input" (12) to, e.g., a video source (e.g. cam-
corder).
28