Conrad 75 20 16 Bedienungsanleitung Seite 25

• In commercial institutions, the accident prevention regulations of
the Employer's Liability Insurance Association for Electrical Sys-
tems and Operating Materials are to be observed.
• All system components are only approved for operation in dry
rooms.
• Make sure that no magnetic or electromagnetic fields or heat sour-
ces are in the vicinity of the product.
• Do not subject the product to heavy mechanical stress. The device
can be damaged under load or when dropped from a low height.
• Consult a qualified person if you are unsure as to operation, safety
or connection of the device.
• Live components may be exposed if covers are opened or parts are
removed (unless these parts are intended to be removed without
tools). Connection points may also be live. If the device needs to be
opened for calibrating, servicing, repairing or replacing parts or
assemblies, it must be disconnected from all sources of current first.
Any necessary servicing or repair on the open device must be car-
ried out by a specialist who is familiar with the risks involved and the
relevant regulations.
• Capacitors in the device may still be charged even after it has been
disconnected from all power sources.
• The euro plug of the power cable may never be plugged in or out with
wet hands. The same applies to the mains unit itself of course.
• Never pull on the mains adapter connection cable. Always unplug it
by pulling on the plug's housing.
• When installing the device, make sure the connection cables are not
squeezed, squashed or damaged by sharp objects.
• Disconnect the power supply if the product is not in use for an
extended period of time.
• The screen's mounting base may be attached stationarily. It is
equipped with three mounting holes in the bottom. Make sure you
do not damage any cables or power lines when drilling holes in the
wall or fastening screws.
• All system components are only approved for operation in dry
indoor rooms.
24