Connection And Operation; Connection And Start-Up - Conrad 75 17 47 Bedienungsanleitung

Remote control view:

7. Connection and operation

• Screw the included aerial onto the transmitter and receiver.
• Connect the "video input" (7) to the video output of, e.g., a camera.
• Connect the "audio input" (6) to the audio output of, e.g., a camera.
• Connect the low voltage plug of the supplied power supply with the "DC IN 7.5V" (5) power connec-
tion on your wireless camera.
• Connect the "video output" (18) to the video input of, e.g., a screen.
• Connect the "audio output" (17) to the audio input of, e.g., a screen.
• Connect the low voltage plug of the supplied power supply with the "DC IN 7.5V" (16) power connec-
tion on your wireless camera.
• Plug the mains adapters into a standard household mains socket (230 V/AC 50 Hz).
• The POWER LED (3, 13) lights up red permanently to indicate that the device is properly powered.
• Switch on your display device and select the desired channel.
If you are not clear about the correct connections, contact our technical support or
another specialist.
To extend the audio and video signal, only use suitably shielded RCA cables. The
use of other cables might cause interferences. Keep the length of the cable as short
as possible.
: Navigation buttons
: Menu button
: Zoom button
: Select/Pair button
41