Conrad 75 17 47 Bedienungsanleitung Seite 62

Problem
The software does
not receive camera
images from the
PC or laptop.
The software does
not display any
images.
Poor image quality
The camera image
only shows a very
small area.
Image is not
displayed on the
TV set or monitor.
System message
unintelligible.
Motion detection
does not work
properly.
Video clips cannot
be played back.
Display in the
software is frozen.
The software does
not function any
more after 1 hour.
Possible cause
USB receiver not configured
properly.
Receiver is not supplied with power. Check the connection of the wall
Transmitter/camera and receiver
have not been paired.
Wrong receiver channel chosen.
Camera is out of range or signal
is too weak.
Resolution set too low.
Zoom is active.
USB mode is active.
Wrong language selected.
Sensitivity level set too low.
Wrong settings.
Your player does not support the
XviD codec.
Windows power save mode
is active.
You have not registered the
software.
Recommendation
See chapter „10.5. Configuring the
receiver as „Digital Wireless
Camera".
power supply.
See chapter: „10.8 Settings – Pairing"
Click on one of the icons
correct camera channel.
Position the transmitter/camera closer
to the receiver. Try to improve the
radio signal by readjusting the aerials
of the receiver and the
transmitter/camera. Keep the trans-
mitter/camera and the receiver away
from metallic objects or radio devices
(WLAN router, mobile phones etc.).
See chapter:
„10.10 Recording settings"
Use the button to zoom out.
As soon as the receiver is connected
to the PC via USB, there is no
signal over "Video output" (18) out
any more. First disconnect USB
connection.
See chapter:
10.15 Language selection
See chapters:
„10.9 Motion detection settings"
and "10.10 Recording settings".
Download the latest XviD codec.
http://www.xvid.org
See chapter: „11. Registration".
to select the
61