Setting The Volume; Restore Factory Settings (Reset); Usb Connection And Operation On A Pc - Conrad 75 17 47 Bedienungsanleitung

8.6 Setting the volume

You can set the volume level (0 to 20). To do so proceed as follows:
• Press the MENU button
• Press the "up"
• Press the "left"
• Press the MENU button

8.7 Restore factory settings (RESET)

Proceed as follows to restore factory settings:
• Press the MENU button
• Press the "up"
• Press the channel selection button

9. USB connection and operation on a PC

Quick overview:
- Install the provided iSEC Guarding Software
- Restart Windows
- Connect the receiver to the PC using the provided USB cable (see figure below).
- Run the installed iSEC Guarding Software
This quick overview is only designed to give you an idea of how to proceed.
To ensure proper operation on the computer, please observe the following items.
Note that the receiver switches to USB mode as soon as it is connected to the PC.
This means that "video out" (18) will be deactivated and that the receiver is powered
via USB with 5V/DC.
So do not connect the wall power supply when the receiver is operated on a PC.
Also cut off the connection to your monitor.
To play back the camera feed on your monitor via the "video out" (18) socket,
separate the USB connection between the receiver and the PC.
. The settings menu opens up.
or "down" buttons to select menu item "Audio vol".
or "right" buttons to select the desired volume.
to accept the settings.
. The settings menu opens up.
or "down" button to select menu item "Reset".
to restore factory settings.
45