Inserting/Changing The Batteries Of The Remote Control; Installation - Conrad 75 17 39 Bedienungsanleitung

LightFrequence: Indicates the grid frequency for the plug-in mains adapter. If you
are not sure about this setting, ask a specialist (Germany = 50).
ImageQuality:Indicates the set image quality. You can adjust the image quality in
3 stages. 1 = low quality (but low storage consumption), 2 = medium image quality,
3 = high image quality (but higher storage consumption).
Overwrite: Can be set to 1 or 0. 1 means that the first recorded data is automati-
cally overwritten and replaced when the Micro SD memory card is full. 0 means that
no further recordings can be saved onto a full Micro SD memory card.

9. Inserting/Changing the Batteries of the Remote Control

When the remote control range or the LED lighting intensity on the remote control
decreases, batteries must be replaced. For this purpose, proceed as follows:
• Draw the battery compartment cover on the back carefully downwards.
• If necessary, replace the discharged battery.
• Insert a 12V battery (Type 23A. Observe correct polarity!
• Replace the lid of the battery compartment.

10. Installation

Find a suitable place for mounting from which the area to be monitored can be
observed.
A suitable place for installation of this camera has the following features:
• Vibration-free
• No direct sunlight
• Dry indoor conditions
31