Automatic Motion Detection - Conrad 75 17 39 Bedienungsanleitung

Press the "Multi function button" (6) once to stop the recording.
To record a video , you may also use the "REC"
"STOP" on the remote control to stop the recording when desired.
The maximum recording time is 30 seconds. After 30 minutes, the
recording is stored and stopped.
The shortest recording length is 18 seconds.

12. Automatic Motion Detection

Put the "Video/photo" slider (9) into the desired position (= photo or video mode,
indicated by a camera or video camera symbol). Hold down the "Multi function
button" (6) for 5 seconds to switch on the camera.
To activate automatic motion detection, press the "DETECT" (5) button or the
"MOTION DETECT ON"
mation that automatic motion detection is active, the green and blue"Video/photo"
status LEDs (8) light up.
When a motion is detected, a recording is made. Depending on whether the
"Video/photo" slider is in the video or photo position, a video or photo recording is
made.
When a motion is detected in video mode (the "Video/photo" slider (9)
is in the video position (=left position, indicated by a video camera sym-
bol), a video is recorded. The shortest recording length is 18 seconds.
If the motion lasts longer than 18 seconds, a recording may take up to
30 minutes. After 30 minutes, the recording is stopped and stored.
To deactivate automatic motion detection, press the "DETECT" (5) button again or
press the the "MOTION DETECT OFF"
button on the remote control once. For optical confir-
button once.
button once. Use the button
35