Conrad WS55 Bedienungsanleitung Seite 58

Problem
Problem with
synchronization
58
Solution
• When inserting the batteries in the outdoor sensors and the
base station (strictly observe the sequence!) these devices
are in the synchronization mode.
Each 4 seconds a data telegram is transmitted which accel-
erates the identification and registration of the outdoor
sensors at the base station.
In order to force a new synchronization, remove the batter-
ies from the base station and from the outdoor sensors.
Wait afterwards for at least 60 seconds before inserting the
batteries again in the outdoor sensors and then in the base
station (it is imperative that you observe this sequence – first
insert the batteries in all existing outdoor sensors and
afterwards in the base station).
Thereby, all values/data that were saved by the base station
(e.g. min. values, max. values, temperature threshold val-
ues) will get lost.
• Before installing the outdoor sensors e.g. in your garden,
carry out a function test as described at the beginning of
chapter 8.