Conrad WS55 Bedienungsanleitung Seite 42


If the address was modified at pool sensor "PS55" via its DIP switch (for address
setting see instructions specific to "PS55"), then display A must be reset
according to chapter 10.b) to the number of this sensor (1...8).
Lower line ("display field B", see chapter 9):
Temperature and air humidity of the indoor sensor
Comfort indicator and trend indicator
• The base station can be either hung on the wall (a corresponding opening is on the rear
side) or installed on a horizontal surface via its foot stand.
• If you wish to use the foot stand, you must insert both lower spikes of the foot stand from
the rear into the recesses underneath the battery compartment and pivot the foot stand
forward until the other two spikes of the foot stand lock in place in the openings on the lower
part of the display device.
42