Werbung
No.
Page
Item
2
2-33
2.2.4.4
Setting the date
and time
3
2-63
2.5.6
Setting a
reserved SB
4
4-3,
4.2
PSA Installation
4-4
(Linux: Red
Hat)
(PRIMEQUEST
580A/540A/580
/540/480/440)
Addition
However, if the time difference is equal to or greater than 0.5 second because of leap
seconds, the time may fail to be adjusted. This is possible even during operation in Slew
mode with the following firmware versions. For the relevant version, update the
firmware to the latest version.
- Firmware versions for which the time fails to be adjusted in Slew mode because of
leap seconds
PQ520:
PQ580/540:
PQ510A:
PQ520A/520X:
PQ580A/540A:
Method of confirming the time synchronization with the NTP server
For information on how to confirm that the time has been synchronized with the NTP
server, consult your Fujitsu certified engineer or the support center.
Incorrect
3 [Replacement Condition] sets the condition that determines the timing at which the
reserved SB is to be switched.
(PRIMEQUEST 580A/540A/520A or PRIMEQUEST 500 series running MMB
firmware whose version level is 3.24 or later)
Correct
3 [Replacement Condition] sets the condition that determines the timing at which the
reserved SB is to be switched.
Note: For PRIMEQUEST 580A/540A/520A or PRIMEQUEST 500 series running MMB
firmware whose version level is 3.24 or later, this item can be set.
- SB failure: If an SB in the partition is degraded, it is replaced with the
specified Reserved SB.
- CPU/DIMM failure: If a CPU or DIMM on an SB in the partition is
degraded, the SB is replaced with the specified Reserved SB.
The default value is [CPU/DIMM failure].
Incorrect
- During PSA installation, the following modifications required for PSA operation are
automatically put into effect:
- Adding of settings to syslog.conf
- Adding of settings to snmpd.conf
- snmptrapd.conf file setup
- Disabling of salinfo or salinfo_decode automatic startup setting (*1)
- Disabling of smartd automatic startup setting
- Adding of description to the services file (*2)
*1 These automatic startup settings are disabled because of conflicts with some
PSA functions.
*2 Added Port:
Port numbers are not checked for duplication when contents are added to the
fj-webgate (24450) services file. Change them as necessary.
Description
3.24 and 3.25
3.24 and 3.25
4.14 and earlier
4.17 and earlier
4.17 and earlier
4
Werbung
Kapitel
