Werbung
New items are
marked yellow. All
other items have
been incorporated
Table of corrections in PRIMEQUEST 500A/500/400 Series Installation Manual
in the manual.
Erroneous descriptions that were found in the manual have been corrected as shown below.
No.
Page
1
2-23
2.2.3.5
SMTP settings
2
2-33
2.2.4.4
Setting the date
and time
Item
Incorrect
Note: A DNS server must be specified prior to specifying a fully qualified domain name
Correct
Note:
- The From address for sending mail to the SMTP server when Alarm E-Mail is sent is as
follows depending on the format set from [Network Configuration] [Network
Interface]:
The mail address that is set in From is used as the From address for sending mail to the
receiving (To) address.
-
To specify an FQDN for the SMTP Server name,
The DNS server can be set by selecting [Network Configuration] [Network Interface].
Addition
(Addition of the following after step 3)
NTP operation specifications
1. Models covered by these specifications:
2. Specifications of operations starting NTP client time synchronization
The NTP client of the MMB starts time synchronization at the start of operation
regardless of any time difference with the NTP server.
The timing of the start of operation of the NTP client of the MMB is as follows:
(1) It starts when the NTP service of the MMB is activated (when [Network
(C122-E001-10EN)
Description
(FQDN). You can specify it by selecting [Network Configuration] [Network
Interface].
FQDN format
root@[Hostname]
Other than FQDN format root@[Hostname].[Hostname]
PQ480/440/420
PQ580/540/520
PQ580A/540A/520A/520X/510A
Configuration] [Date/Time] is selected from the MMB Web-UI, [Enable] is
checked for [NTP] in [Date/Time], and the [Apply] button is clicked).
1
2009/6/18
the DNS server must already be set.
Werbung
Kapitel
