Ryobi RLT4025 Bedienungsanleitung Seite 16

GB
F D E I
Line will not advance when
you restart the machine.
Cutting head is hard to turn.
Grass wraps around the out
put shaft and the trimmer head
assembly.
Liner trimmer stops and will
not start again.
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this product for environmental safe
recycling.
P NL S DK N FIN GR HU
English
TROUBLESHOOTING
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up
around head.
Cutting tall grass at ground
level.
1) Unit failed
2) Plug is damaged.
DISPOSAL
CZ RU RO PL SLO HR TR EST LT
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing the Cutting
Line" earlier in this manual).
3. Pull lines while alternately pressing down on and
releasing bump button.
4. Remove line from spool and rewind (Refer
to "Replacing the Cutting Line" earlier in this
manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
1) Contact dealer to check damage
2) Check the plug
14
LV SK BG