Delivery Scope - Bosch PCM 8 S Originalbetriebsanleitung

Assembly
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.

Delivery Scope

Please also observe the repre-
sentation of the delivery scope
at the beginning of the operat-
ing instructions.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Sliding mitre saw with premounted saw
blade
– Dust bag 1
– Locking knob 13
– Extension bar 19 (2x)
– Fastening kit for extension bar 38
(2 U-profiles with screws)
– Saw-table extension 37
– Length stop 36
– Quick-action clamp 47
– Allen key/Phillips screwdriver 20
– Batteries (3x, size AAA, 1,5 V)
for machine versions with base unit:
– Base unit 40
(16 Profiles, 4 end caps)
– Fastening kit for base unit 41
(24 screws with nuts for assembly, 4 screws
with nuts for fastening of the machine, 4
washers)
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Bosch Power Tools
Mounting Individual Components
– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material from the ma-
chine and the accessories provided.
– For easier working when mounting the sup-
plied product features, please observe that
the machine is in the transport position.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Angle gauge
– Box-end or open-end spanner (size 12 mm)
for assembly of the base unit
– Box-end or open-end spanner (size 14 mm)
for the lock nuts of the depth stop
– Box-end or open-end spanner (size 10 mm)
for basic adjustment of the bevel angles
(vertical)
Mounting the Saw Table Extension and the
Length Stop
(see figure A)
The saw table extension 37 and the length stop
36 can be positioned left or right from the ma-
chine.
– Mount the saw table extension and the
length stop to the requested extension bar
19 as required and tighten the corresponding
wing nut.
Mounting the Extension Bars
(see figure A)
For mounting, use the extension-bar fastening
kit 38. (2 U-profiles with screws)
– Tilt the power tool in such a manner that the
extension bars can be affixed to the bottom
side of the saw-table casing.
– Hold a U-profile over a casing fin 39 so that
the drill holes of both parts are in alignment.
– Insert an extension bar through the drill
holes 18, the U-profile and the casing fins to
the stop.
– Tighten the screw of the U-profile to secure
the extension bar.
– Repeat the work steps for the second exten-
sion bar on the other side of the saw-table
casing.
English | 41
1 609 929 J50 | (27/11/07)