Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch PCM 8 S Originalbetriebsanleitung

40 | English

Technical Data

Sliding Mitre Saw
Article number
Rated power input
Rated voltage
Frequency
No-load speed
Laser type
Laser class
Weight according to
EPTA-Procedure
01/2003
Protection class
Maximum workpiece dimensions, see page 45.
Starting cycles generate brief voltage drops. Interfer-
ence with other equipment/machines may occur in case
of unfavourable mains system conditions. Malfunctions
are not to be expected for system impedances below
0.24 ohm.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Saw blade mounting
hole
1 609 929 J50 | (27/11/07)
PCM 8 S
3 603 L02 0..
W 1200
V 230
Hz 50
rpm 5200
650 nm, < 1mW
kg 18.7
mm 210
mm 1.4–2.0
mm 30

Noise/Vibration Information

Measured values determined according to
EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 98 dB(A);
Sound power level 111 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
The hand-arm acceleration is typically below
2
2.5 m/s .
2

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
/ II
standardization documents: EN 61029,
EN 60825-1 according to the provisions of the
directives 2004/108/EC, 98/37/EC (until Dec.
28, 2009), 2006/42/EG (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
27.11.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools