Fault Analysis And Handling - SPORTSTECH F50 Benutzerhandbuch

12. FAULT ANALYSIS AND HANDLING

FAULT CODE
E01
E02
E03
E04
E05
E06
E07
E08
CAUSE
Poor communication between
Computer PCB and controller.
Protection against blast shock.
Failure of speed induction.
Failure of incline learning.
Over-current protection.
Error in power-on self-test of
controller.
Loss of parameter.
Safety lock.
109
SOLUTION
1. Inspect whether connecting
line between electronic meter
and controller suffers from poor
contact.
2. Poor contact of main IC of
controller. Reinsert it.
3. Power of controller is abnormal.
Replace controller.
1. Open circuit or poor contact of
motor. Replace motor or check
connector.
2. Breakdown of power tube.
Replace power tube or
controller.
1. Speed sensor is damaged.
Replace it.
2. Speed sensor is not in correct
place. Adjust its position.
Replace ascension motor
1. Overload.
2. Resistance of running platform
is too high, and it shall be oiled.
3. Motor is damaged. Replace it.
Replace controller
Replace controller or input parameter
again
Please connect safety lock