Safety Notes - Wetekom 9804 Bedienungsanleitung

Please note the following safety notes to avoid malfunctions,
damage or physical injury:
Before taking any measurements always check the device, the measuring
cables and any other accessories for possible damage. In the event of any
damage do not attempt to take measurements. Replace defective parts.
Do not exceed the maximum allowable input voltage (see technical data).
Do not exceed the maximum allowable input values for any measurement
function.
Before changing the measuring range with the rotary function switch (3)
always remove the probes from the device from which measurements are
being taken.
When carrying out measurements of over 120 V DC or 50 V AC, always
follow the relevant safety regulations. Disconnect the circuit from the
power supply before connecting the probe tips.
Do not connect any power source to the "A"- and the "µA / mA"-inputs. If
this advice is not strictly followed, the device may be damaged and injuries
may occur.
Do not touch bare wires or live areas of the device during measurements.
Do not connect the measuring probes to a power source while the unit is
set to continuity test, transistor, capacity and resistance measurement,
diode test, or current measurement.
Do not reach over the safety ring when handling the probes. This way, it is
not possible to contact the metal tips of the probes when taking measure-
ments (danger of an electric shock!).
Only use original accessories.
Keep the device out of the range of children.

1. Safety Notes

23