Initial Operation - Bosch PDO 6 Originalbetriebsanleitung

OBJ_BUCH-308-002.book Page 20 Wednesday, November 3, 2010 9:44 AM
20 | English
Operation

Initial Operation

Protect the measuring tool against moisture and
direct sun light.
Switching On and Off
Before switching the measuring tool on, make sure
that the sensor area 5 is not moist. If required, dry
the measuring tool using a soft cloth.
Do not subject the measuring tool to extreme tem-
peratures or variations in temperature. As an ex-
ample, do not leave it in vehicles for longer periods.
In case of large variations in temperature, allow the
measuring tool to adjust to the ambient tempera-
ture before putting it into operation.
Avoid heavy impact to or falling down of the meas-
uring tool.
To switch on the measuring tool, press the On/Off but-
ton 4.
After a brief self-check, the measuring tool is ready for
operation. The operational readiness is indicated by a
check mark behind the "AutoCal" calibration indicator
d.
To switch the measuring tool off, press the On/Off but-
ton 4.
When no measurements are carried out for approx.
10 minutes, the measuring tool switches off automati-
cally in order to extend the service life of the batteries.
Before drilling, sawing or routing into a wall, pro-
tect yourself against hazards by using other infor-
mation sources. As the measuring results can be in-
1 609 929 X43 | (3.11.10) Bosch Power Tools