Operation; Setting And Indication Of The Time - Renkforce MS-11425 Bedienungsanleitung

Open the battery compartment at the back of the remote control. Insert two new 1.5V micro-batteries
(AAA) in the battery compartment, paying attention to the polarity markings The correct polarity is
stamped in the bottom of the battery compartment . Close the battery compartment.
When the range of the remote control deteriorates or the remote control ceases to function properly, bat-
teries should be replaced as described above.
Batteries with varying states of charge or from different manufacturers should never be mixed.

Operation

The audio centre is capable of playing music held in MP3 format. MP3 is a data format used to compress
music into files of more manageable size. Load the MP3 files on to a CD, memory card or USB stick and
play these on the audio centre without the need to connect this to your computer.
Please note the following for the compilation of MP3 files:
- Do not mix MP3 files on the CD/USB stick/memory card with other files types (e.g. WMA files).
- Don't use MP3 files with bit rate in excess of 256 kbit/s.
- Use a lower burn speed on CD compilation
- Change CD manufacturer should problems occur on playback.

Setting and Indication of the Time

1. The device must be in stand-by mode before the time can be set.
2. Press and hold the PROG/MEM (MEMORY/CLK-ADJ) (11) button for 2 seconds in order to set the
device to time-set mode. „24 HOUR" will flash in the display.
3. Using the IGG DOWN/REW or UP/FF buttons DDI (3) select either 24 or 12 time format.
4. Press the PROG/MEM (11) button and using the IGG DOWN/REW or UP/FF button DDI (3) set the
hour. Pressing and holding the button (3) starts fast skip mode.
5. Press the PROG/MEM (11) button and using the IGG DOWN/REW or UP/FF button DDI (3) set the
minute. Pressing and holding the button (3) starts fast skip mode.
6. Press the PROG/MEM (11) to save this time.
If no entry is made for a period of ten seconds or longer during the setting of the clock,
the device will automatically switch out of time set mode.
Switch the HiFi on using the POWER button (1). Press and hold the MEM button (11).
The time will appear and remain in the display. Press the MEM key (11) or the FUNC-
TION (8) button to end the setting.
39