Radio Mode; Programming Of Radio Stations - Renkforce MS-11425 Bedienungsanleitung

Radio Mode

1.Press the POWER button (1) either on the remote control or directly on the audio centre itself to switch
on the device.
2. Press the "FUNCTION" key (8) as often as necessary to switch the device into radio mode. The word
„TUNER" appears for a short period in the display. You can also switch into radio mode by pressing
the TUNER/BAND (9) button.
3. Select the desired radio frequency (MW or FM) with the TUNER/BAND button.
4. Press and hold the DOWN/REW button IGG or the UP/FF button DDI (3) until the automatic search
begins. The station search stops at the first broadcasting station with good reception quality. To restart
the station search, press and hold one of the buttons again until the station search starts. The search
is interrupted by pressing the button (3) again.
5. Reception frequency can also be set manually using the buttons (3). This is done by pressing the IGG
DOWN/REW or UP/FF button DDI (3).
6. Set the required volume using the volume control (6) on the audio centre, alternately using the volume
buttons (25) on the remote control.
7. Where reception of an FM stereo station is weak, switch to mono. To do this, press the ST./MONO but-
ton (30). As soon as a new search is begun and a stereo station found, the device will switch back to
stereo mode. ((ST)) will appear in the LCD display.

Programming of Radio Stations

1. Set the desired radio frequency using theIGG DOWN/REW or UP/FF button DDI (3) as described
above.
2. Press the MEM key (11).
3. Select the desired memory position using the buttons PRESET -/+ (29) on the remote control.
4. The radio station heard can be saved to memory using the MEM button (11).
5. Repeat steps 1 -4 until you have programmed all stations.
6. Recall of the desired memory position is made using the PRESET buttons (29) on the remote control
whilst in radio mode.
30 FM and 10 MW stations can be saved. If no entry is made for a period of five sec-
onds or longer, the device will automatically switch out of programming mode.
40
Operating instructions
English