Taking Pictures / Video While Measuring Temperature - VOLTCRAFT IR1000-50CAM Bedienungsanleitung

The "ALARM LOW" is active.
The "ALARM HIGH" is active.
Laser has been emitted.
Type-K thermal couple measuring
1. Insert the K-type wire sensor into the K-type socket (10) of the device.
2. Enable the display of "TYPE-K" in the sub-menu. (See the previous session.) Note that the TK reading
will not be shown if the "TYPE-K" function is disabled or if the K-type wire sensor is not connected.
3. Place the end of the K-type wire at the desired place.
13. TAKIng PICTuREs / VIdEO WHIlE
MEAsuRIng TEMPERATuRE
1. Use the button photo / up arrow (5) and the button video / down arrow (3) to select the option "IR
CAM" and confirm by pressing the button ENTER (6). Then you will first enter the camera mode. A
symbol will be shown on the display.
2. Press the button "ENTER" (6) to enter the sub-menu for setting the parameters of this mode. The
measuring speed of "IR CAM" mode is slower than the "IR MEASURE" mode.
3. Aim at your target object and you can watch it on the display.
4. Press the button trigger (7) to measure the temperature of the target object.
Taking pictures
1. In camera mode, press the button photo / up arrow (5) to take a picture. If no measurement has
been taken in the session, the picture will not contain any measurement. If a measurement has
been taken, the latest measurement will be included in the picture.
2. A preview will shows up, press the button photo / up arrow (5) to select the "SAVE", press the
button video / down arrow (3) to select "CANCEL".
Taking videos
1. Press the button video / down arrow (3) to switch to video mode. A symbol
2. Press the button video / down arrow (3) again to select "START" and start recording.
3. Press the button video / down arrow (3) again to select "STOP" and stop recording. You will see
the text "SAVING FILE..." when you stop recording.
4. Press the button ESC / power (4) to return to camera mode.
The target object temperature falls
below the "ALARM LOW" setting.
The target object temperature exceeds
the "ALARM HIGH" setting.
shows on the display.
35