Continuous Measurement - VOLTCRAFT IR 1201-50D Bedienungsanleitung

Confirm the selection with "OK" (Button "F2"). Press the measuring button (5) or "MODE" to exit the settings menu.
Following the technical data you will find a table with common materials and their emission levels.
Many organic materials have an emissivity of 0.95. Therefore, the default emission level setting is 0.95.

Continuous measurement

The measuring device is equipped with a continuous measurement mode.
Turn the measuring device on by briefly pressing the measuring button (5).
Select the settings menu
Turn continuous measurement on/off with "F1". Press the button once to turn on the function and again to turn it off.
When the continuous measurement function deactivated, the measuring button (5), the "MODE" button and
the automatic power-off function are out of operation.
Display backlight (quick setting)
You can set the display backlight via the direct menu.
Turn the measuring device on by briefly pressing the measuring button (5).
Select the settings menu
Set the display backlight with "F2" via the "Lit" function. Each time you press the button, the backlight brightens one
step and starts over after the brightest level.
44
with the "MODE" button within the pre-set power-off time.
with the "MODE" button within the pre-set power-off time.
Continuous measurement off
Continuous measurement on