VOLTCRAFT IR 1201-50D Bedienungsanleitung Seite 46

During measurement, a signal sounds when the corresponding alarm level is reached, the display lights up red and
the symbol "Hi" or "Lo" starts to flash.
The set alarm values are retained after power-off.
Data transmission via USB
The measuring device is equipped with a USB interface for the transmission and storage of data on a computer.
Proceed as follows to connect the infrared thermometer to your computer:
Start up your computer with Windows 2000 or higher.
®
Insert the supplied software CD into a CD drive and follow the instructions on the screen.
If the automatic program installation does not start, select the CD drive in Explorer and start the installation program
"setup.exe" manually. Follow the on-screen instructions.
After successful program installation, install the USB driver manually. To do so, select the CD drive in Explorer and
open the file "USB Driver". Start the installation program "cp210xVCPInstaller.exe" manually. Follow the on-screen
instructions.
Activate the USB interface from the device in the system settings menu "Set" under "Send Data".
Activate/deactivate the continuous measurement function to prevent automatic power-off during any breaks in
measurement. The data transfer takes place only when the measuring device is switched on.
Open the side cover (1) on the device. Plug the USB cable provided into the Mini-USB socket on the side and connect
the other end of the cable to a free USB port of your computer.
The computer automatically detects a new device. After successful installation, you can start the measurement
software.
The display shows "Connected" when the data link is successful.
The program settings and operation can be found in the software's help menu (Help). Infrared readings as well as
contact temperature readings are transferred to your computer.
After the data transfer, deactivate continuous measurement and turn off the interface from the measuring device.
46