Servicing - Wolf Garten 72V Li-Ion Power 30T Originalbetriebsanleitung

EN
Adjusting the working angle (Fig . K )
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
line.
¾ Always remove the power pack prior to
working on the device.
The trimmer can be set in any of four different
operating angles. This allows you to easily reach
problematic and difficult-to-access positions in the
garden.
Press and hold the locating button.
Î
Set the operating angle Kabcd .
Î
3 The arm engages audibly.
Release the locating button.
Î
Edge cutting function (Fig . L )
The edge cutting function enables precise and easy
cutting along the lawn edge.
Simultaneously turn and pull the handle L 1 .
Î
3 The head of the trimmer can be turned through
90 L 2 .
Inserting the plastic knife (Fig . M )
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
line.
¾ Always remove the power pack prior to
working on the device.
Use the plastic knives Ae , so that it also possible to
trim smaller shrubs such as nettles or brambles.
Simultaneously strongly press both of the en-
Î
gaging lugs of the spool cap together M 1 and
pull it off M 2 .
Turn the spool body in the line box, until the line
Î
only projects about 2 cm from the line box M 3 .
Attach two plastic knives Ae on the spool
Î
cap M 4 .
Î Carefully pull the plastic knives outwards until they
engage M 5 .
Simultaneously strongly press both of the en-
Î
gaging lugs of the plastic knives spool cap Ad
together M 6 and pull it off the line box M 7 .
24 | |
WARNING !
WARNING !
V LI-ION POWER T
Switching the device off (Fig . I )
Î Release the on/off switch to switch the device
off I 2 ..
3 If you release the on/off switch, the releasing
device automatically locks again I 1 .
Power pack removal (Fig . N )
Press the power pack release N 1 .
Î
Remove the power pack N 2 .
Î

Servicing

Risk of injuries or material damage due to
moving parts.
¾ Only clean or service the device if the
motor is stationary and also the cutting
tool.
¾ Always remove the power pack prior to
working on the device.
¾ Repair and service work as well as the
replacement of safety elements must
be performed by a qualified expert or
workshop.
Cleaning the trimmer
Î Switch the trimmer off and wait until the cutting
tool comes to a standstill and remove the power
pack.
Î Clean the device with a hand brush after every
use.
Î Clean the ventilation slots and underside of the
device at regular intervals to remove grass resi-
dues.
Attention!
Never spray the device with water or a pressure
washer.
WARNING !
Servicing