Servicing - Wolf Garten LT 25 eM Originalbetriebsanleitung

EN
Manual E
Risk of injuries due to the cutting tool.
¾ Only adjust the device with the motor
switched off and the cutting tool at a
standstill.
¾ Do not reach into the area of the rotating
line.
¾ Before any work on the device, remove
the operating arm with the permanently
installed power pack beforehand.
Risk of injury on the line cutter
¾ After pulling out new line, always hold
the device in its normal working position
before you switch it on.
Manual line adjustment may be necessary during
first use after changing the line spool.
Press button 1 .
Î
Pull the line out 2 .
Î
Switching the device off D
Release the on/off switch [B] on the handle.
Î
3 The device is switched off.
Note
The cutting tool continues to run for a brief
period after being switched off.
Note
The lock-on switch automatically returns to
its initial position when you release the on/off
switch.
Working on the trimmer F G H
Hold the rotating line roughly parallel to
the ground (not inclined by more than
30°). This trimmer is not an edge trimmer.
Do not incline the trimmer so that the line
rotates at a right angle to the ground. The
resulting flying debris could cause severe
injuries!
With the trimmer switched on, hold it at an appro-
Î
priate angle and move it from side to side F G .
Maintain a minimum distance 610 mm between
Î
your feet and the protective cover H .
24
WARNING!
CAUTION!
WARNING!
Practical trimming tips G H
Cut using the tip of the cutting line. Do not use
Î
excessive force when moving the cutting head
through uncut grass.
Note
Wire and picket fences result in increased
line wear and even in breaking of the line.
The line may wear quickly on stone and
brick walls, kerbstones and wooden surfac-
es.
Do not move the line head over the surface of the
Î
ground or other surfaces.
In the case of long grass, cut from up to down
Î
and doe not exceed the height of 30 cm in the
process.
Hold the trimmer so that it is inclined towards the
Î
area to be cut.
When cutting, rotate the trimmer from left to right.
Î
This prevents cuttings hitting the operator.
Avoid trimming trees and bushes, bark, wooden
Î
slats, wall cladding and fence posts. The line
could quickly and easily damage them.
Removing the operating arm with permanently
installed power pack I
Switching the device off
Î
Press the locking button [A] on the operating
Î
arm 1 .
Pull the operating arm out of the receptacle of the
Î
trimmer unit [B] completely 2 .

Servicing

Risk of injuries or material damage due to
moving parts.
¾ Only clean or service the device if the
motor is stationary and also the cutting
tool.
¾ Before any work on the device, remove
the operating arm with the permanently
installed power pack beforehand.
¾ Do not clean the device with water.
¾ Repair and service work as well as the
replacement of safety elements must
be performed by a qualified expert or
workshop.
Cleaning the trimmer
Switch the trimmer off and wait until the cutting
Î
tool comes to a standstill and remove the oper-
ating arm.
Clean the device with a hand brush after every use.
Î
Clean the ventilation slots and underside of the
Î
device at regular intervals to remove grass resi-
dues.
WARNING!
Servicing