Operating Elements; Putting Into Use; Assembly - Wolf Garten 72V Li-Ion Power 30T Originalbetriebsanleitung

EN

Operating elements

Operating elements (Fig . P )
1 Power pack release
2 Handle
3 Hook for carrying belt
4 Middle handle
5 Height adjustable telescopic arm
6 Adjustment of edge cutting function
7 Protective cover
8 Plant protection bow
9 Shield lock
10 On/off switch
11 Unlock (both sides)
12 End stop height adjustment / middle handle adjustment
13 Working angle adjustment
14 Shield
Power pack compartment
15
16 Carrying belt
17 Wheels bracket
18 Adapter
19 Wheels
20 Spool cap for plastic knife
21 Plastic knife
22 Line box
23 Line spool
24 Spool cap
25 Cutting device for shortening the line length
Information
Operating elements marked with
optionally available as accessories and not
contained in the scope of the delivery.

Putting into use

Supplementary documentation
Make sure the operating instructions
of the POWER Base 72V / POW-
ER Base 72V Basic charger and of the
Li High Energy 72V power pack are
available and that you understand them
and adhere to them .
22 | |
are
V LI-ION POWER T
Power pack charging
Risk of injuries or material damage
¾ Only charge the power pack with
charger POWER Base 72V /
POWER Base 72V Basic.
Attention!
The power pack is supplied partially charged.
Before first use, fully charge the power pack
using the charger POWER Base 72V / POW-
ER Base 72V Basic to ensure the full capacity of
the power pack.
Î Power pack charging must be carried out ac-
cording to the instructions in the supplementary
documentation.
Operating times
Î Observe the times stipulated in local byelaws.
Check if there are any operating time limitations
Î
with your local authorities.

Assembly

Fitting the protective cover (Fig . B )
Forcefully press the protective cover Ac on to the
Î
trimmer B 1 .
3 The protective cover audibly engages.
Attaching the shield (Fig . C )
Note
The shield must be removed before using
the edge cutting function.
The shield Ab prevents the cut material from being
excessively scattered if you are working close to the
edge of the lawn area.
Clip the shield into the protective cover C 1 .
Î
Î Fold the shield lock over the shield to provide
additional securing C 2 .
Attaching the carrying belt (Fig . D )
Attach the carrying belt Af at the two hooks D .
Î
Note
For safety reasons only carry the device
supported over your shoulder and never
around your neck. The belt has a quick
release attachment so that it can be quickly
disconnected in the event of a malfunction.
Operating elements
WARNING !