Servicing / Care; Warranty; Environmentally-Friendly Disposal - Wolf Garten BS 140 eM Originalbetriebsanleitung

Servicing / Care

Note
The operating arm with the permanently
installed power pack should have a charge
status of approx. 60%.
The operating arm can be inserted and
stored the designated charger until the
next used or for long-term storage without
any hesitation. For this purpose however,
remove the mains plug of the charger out of
the mains socket.
Servicing / Care
Risk of injuries or material damage.
¾ Never open the operating arm, in which
the power pack unit is permanently
installed.
¾ Cleaning and care work must only be
performed if the operating arm (power
pack) is separate from the charger /
power tool.
¾ Do not use water to clean the operating
arm, the electric attachment tools or the
charger.
¾ Servicing must only be performed by a
qualified expert.
Keep the operating arm clean and dry.
Î
Clean the contacts of the operating arm with a soft
Î
dry cloth.

Warranty

The warranty conditions of our local company or
importer apply in all countries.
Under the terms of the warranty we will repair faults
on your device free of charge, insofar as material
or manufacturing defects are the cause. To make a
claim under warranty please contact your seller or
your nearest branch.
WARNING!

Environmentally-friendly disposal

Power tools, accessories and packaging must be
disposed of via an environmentally compatible recy-
cling chain.
Power packs/batteries:
Do not dispose of power packs/batteries
with domestic waste, by burning or throw-
ing into water. Power packs/batteries must
be collected, recycled or disposed of in an
environmentally-friendly manner.
Power tool (without power packs/batter-
ies):
Do not throw power tools
into domestic waste! Take it to a
suitable disposal facility.
Important information regarding disposal
The Li-ion power pack of the operating arm
is not replaceable. Once the power tool
reaches the end of its useful life, remove the
LI-ion power pack as described below and
dispose of the complete power pack (with
cable, microswitch and plastic connecting
piece) in accordance with the applicable
regulations at a suitable recycling point or
a collection point for waste electrical and
electronic equipment.
1. Remove the plastic covers on the handle of the
right half housing using a slotted screwdriver F a.
2. Remove the 7 screws of the housing halves on
the handle F b.
3. Remove the two half housings of the handle to
uncover the microswitch F c.
4. At the bottom end of the arm, use a slotted
screwdriver to bend the retaining lug of the tube
upwards so that the plastic connecting piece can
subsequently be removed F d.
5. Remove the lock knob using a slotted screw-
driver F e.
6. Pull the complete power pack, with cable and mi-
croswitch, out of the tube of the operating arm by
pulling on the plastic connecting piece [A] F f.
7. Tape off all contact points.
8. Dispose of the just removed power pack complete
with cable, microswitch and plastic connecting
piece at an appropriate recycling centre, or dis-
pose of it at an official collecting point for waste
electrical and electronic equipment.
EN
17