Spare Parts And Accessories; Troubleshooting - Wolf Garten 72V Li-Ion Power 30T Originalbetriebsanleitung

EN
Risk of injuries or material damage
¾ In case of doubt always consult a specialist workshop.
¾ Before any inspection or any work on the device, switch the motor off and remove the power
pack.
Problem Possible cause
The device switch- The power pack is too hot.
es off.
The power pack is discharged.
The temperature of the device (electronics) is too
high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overvoltage release
Overcurrent release
Power pack temperature too high or too low.
The power pack is defective.
Automatic line The spool is empty.
adjustment does
The toothing between the metal knob and the
not work.
line spool is dirty.
The line has torn off and is pulled into the line
spool.
The line has become caught in the spool.
The line is welded onto the spool.
The line breaks off The spool is too dry.
too frequently.
The line comes into contact too frequently with
fixed objects, e.g. fences, trees, etc.

Spare parts and accessories

Order no .
196-651-650
196-652-000
196-650-650
49ATW1-650
49ATS0-650
731-12818
746-05381
26 | |
Part code
POWER Base 72V
POWER Base 72V Basic 72V charger
Li-High Energy 72V
Transport wheel
Line spool
Plastic knife
Carrying belt
V LI-ION POWER T

Troubleshooting

WARNING !
Part description
72V charger
72V power pack
-
-
-
-
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary,
clean the ventilation slots
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
If this occurs again take your device to a
specialist workshop.
Allow the power pack to cool or heat up.
Replace the power pack.
Replace the line spool.
Use a brush to remove dirt from the
parts.
Take off the line spool, if necessary re-
wind the line by gently pulling and insert
the spool.
Remove the welded line part, if neces-
sary rewind the line by gently pulling and
insert the spool.
Place the coil in a water-filled container
for about 24 hours, then dry it off and
refit it.
Use the plant protection bow.
Troubleshooting