B) Setting Up A Master-Slave Chain - MC Crypt GLPS320-RGB Bedienungsanleitung

10. DMX Connection

b) Setting up a Master-Slave Chain

The laser can be operated controlled by a DMX controller or in a master slave chain. In that case, the integrated
controller of the master device controls the connected slave devices.
• Connect the DMX OUTPUT (3) port of the master device to the DMX INPUT (4) port of the first slave device.
• Connect the DMX OUTPUT (3) port of the first slave device to the DMX INPUT (4) port of the subsequent slave
device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUTPUT (3) port of the last slave device (as described
in section "Connection of a DMX controller").
38