MC Crypt GLPS320-RGB Bedienungsanleitung Seite 35

7. Installation
• Attach the device to the ceiling or a suitable crossbeam system. Attach it with the assembly bore of the assembly
bracket. The mounting material and accessories used must be suitable for the attachment type and able to bear
the load of the device.
• Use a self-securing nut or screw at the attachment point for attachment.
• Align the laser effect as desired after assembly and tighten the two clamping screws of the assembly bracket well.
• Additionally secure the installation with a suitable and certified safety retention rope or safety net with a load
carrying capacity of 12 times the device. The device has an eye for the safety catching cable (2) to attach the safety
cable.
• The safety retention rope or the net must be designed to support the effect light in the event of failure of the main
support system independently of the main attachment. The effect light must be caught after free fall of no more than
20 cm if the main support system is defective.
35