Intended Use; Symbols - MC Crypt GLPS320-RGB Bedienungsanleitung

2. Intended Use

The laser is used to generate laser light effects in light show equipment and is controlled by the built-in or an external
DMX controller.
ATTENTION: The laser is intended for the professional area only.
The product is only intended for connection to 100-240 V/50/60 Hz mains sockets with protective contact of the public
mains grid.
The DMX connection must only be connected to suitable DMX controllers or other DMX devices.
The safety provisions and standards for operation of lasers must be observed.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided
under all circumstances.
Any use other than that described above is not permissible. Additionally, this is connected to dangers, such as injury
to the eyes, short circuit, fire, etc.
The entire product must not be modified or converted, and the casing must not be opened.
The safety information must be observed at all times.
Attention! The high laser output of the product causes a high risk of health damage if not
observed.
Therefore, read all the operating instructions attentively before assembly and commissioning
and observe the safety notes contained in them.

3. Symbols

The symbol with a lightning bolt in a triangle is used where there is a health hazard, e.g. from
electric shock. The device contains no parts that require servicing by the user. Therefore, never
open the device.
The arrow symbol indicates special advice and operating information.
The exclamation mark indicates important notes in these operating instructions that must be
strictly observed.
This symbol on the device indicates that the user must read these operating instructions before
using the product and observe them during operation.
This symbol with the house informs the user that the device must only be used in closed rooms.
This symbol indicates the minimum distance to the illuminated surfaces.
...m
28