Operation; Dmx Address - Cameo CLZW600 Bedienungsanleitung

NOTES: In order to provide protection from spraying water, in accordance with protection class IP65, special IP65-rated XLR connectors
must be used correctly with the DMX input and output sockets, or they must be closed using the rubber sealing caps. When connected
correctly, or when sealed correctly with the rubber sealing caps, the POWER IN and POWER OUT sockets are protected from spraying water,
as in accordance with IP65.
PLEASE NOTE
• As soon as the spotlight is correctly connected to the power supply, the following will be displayed in succession during the starting
process:
"Welcome to Cameo", the model name and the software version.
After this process, the spotlight is ready for operation, and starts in the previously enabled mode.
• If one of the DMX operating modes is activated and there is no DMX signal to the DMX input, the currently programmed
DMX address is displayed and the characters on the display will begin to flash.
• After approximately 1 minute of inactivity, the display will automatically show the currently active operating mode.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access
to previously selected menu items and sub-menu items.
1. Press MODE and ENTER simultaneously for direct access to the last-edited sub-menu item,
where you can make changes instantly as required
(DMX starting address and all modes).
2. Press MODE for direct access to the last-selected and last-edited menu item.
Press ENTER repeatedly to access the sub-menu items in order
to change individual settings (DMX starting address and all modes).
• Before changing device settings, ensure that the control panel is dry and dust free
so that its functionality is not impaired.
• The display can be rotated 180° by pressing UP when the main display is visible.

OPERATION

MAIN DISPLAY
After the power-up process, the spotlight is ready for operation, and starts in the previously activated mode. The main display appears with
the following information: current mode (in the example DMX mode) and W-DMX™ status.
W-DMX™
1. To pair with W-DMX™-compatible transmitters, enable W-DMX™ in the device settings (Settings -> Wireless Setting -> W-DMX On Off
-> On) and reset the W-DMX™ module (Receive Reset -> Yes). Start the pairing process as described in the operating instructions of the
W-DMX™ transmitter. Pairing is then completed automatically.
2. Pair a group of W-DMX™ devices to create a DMX universe with them. First decouple all devices that should form the group (Settings ->
Wireless Setting -> Receive Reset). Then select a CLZW600 with a DMX controller via DMX cable and select "Transmit" in the settings (Settings
-> Wireless Setting -> Operating Mode -> Transmit). Select "Receive" in the settings of the W-DMX™ device that you want to control via
W-DMX™ (Settings -> Wireless Setting -> Operating Mode -> Receive), and pair it by selecting "Link" in the settings of the DMX cable
controlled CLZW600, then confirm your selection (Settings -> Wireless Setting -> Link -> Link). Pairing is then completed automatically.
3. It is also possible to create a connected group of W-DMX™ devices via W-DMX™, and operate them in master/slave mode. First
decouple all devices that should form the group (Settings -> Wireless Setting -> Receive Reset). In the settings (Settings -> Wireless Setting
-> Operating Mode) of the master unit select "Transmit", and in the settings of the slave units select "Receive". On the master unit select
"Link" (Settings -> Wireless Setting -> Link -> Link) and confirm your selection by pressing ENTER. Pairing of the devices is then completed
automatically. On the master unit select one of the standalone modes (Auto, Color Macro, Static, Tunable White, User Color), and use this to
control the slave unit.
6
W-DMX™ status

DMX address

001
Current operating mode