Cameo CLZW600 Bedienungsanleitung Seite 8

CONFIGURING STANDALONE MODE
Press MODE to access the device settings selection menu (--- Menu ---). Use UP and DOWN to select the menu item "Stand Alone" (observe
arrow) and confirm with ENTER. In the sub-menu you can use UP and DOWN to select one of the following standalone modes: "Auto", "Color
Macro", "Static", "Tunable White" and "User Color". Confirm your selection with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
AUTO MODE (programme 1 to programme 6)
The 6 different auto-programmes each comprise non-editable colour-change sequences. Brightness and speed are independently adjustable.
Select auto mode as described above under "CONFIGURE STANDALONE MODE" and confirm with ENTER. Now use UP and DOWN to select one
of the 6 auto programmes (observe arrow) and confirm with ENTER. To adjust brightness, use UP and DOWN to select the menu item "Dim" and
confirm with ENTER, then use UP and DOWN to select the desired value between 000 and 255. Confirm by pressing ENTER. Set the run speed
by selecting the menu item "Speed", confirm with ENTER, and then select the desired value between 001 and 100. Confirm by pressing ENTER.
Press MODE four times to return to the main display (Mode Auto).
---------------- Mode ----------------
Auto
Color Macro
Static
Tunable White
User Color
COLOUR MACROS (Color Macro)
15 different preset colour macros are available. Select colour macro mode as per the procedure previously described in SETTING OPERATION
MODE and confirm with ENTER. Now use UP and DOWN to select the desired colour preset (observe arrow) and confirm with ENTER (Color Off =
blackout). A three-digit figure is shown on the display, and you can set the desired brightness on a scale from 000 to 100 using UP and DOWN.
Confirm by pressing ENTER. Press MODE three times to return to the main display (Color Macro Mode).
---------------- Mode ----------------
Auto
Color Macro
Static
Tunable White
User Color
STATIC MODE (Static)
The static mode allows the functions Dimmer, Strobe, R, G, B, W and Color Temp to be adjusted directly on the device with values between
000 and 255, in a similar way to a DMX controller. In this way, an individual scene can be created without the need for an additional DMX
controller. Select static mode as per the procedure previously described in SETTING OPERATION MODE and confirm with ENTER. Now use
UP and DOWN to select the menu item you wish to edit (observe arrow) and confirm with ENTER. The display will now show a three-digit
number field, and you can use UP and DOWN to configure the desired value between 000 and 255. Confirm by pressing ENTER. Press MODE
three times to return to the main display (Static Mode).
8
----------------- Mode ----------------
Auto
Color Macro
Static
Tunable White
User Color
---------------- Auto ----------------
Program 1
Program 2
Program 3
Program 4
Program 5
Program 6
------------ Color Macro ------------
Color Off
Red <100>
Amber <100>
Yellow Warm <100>
Yellow <100>
Green <100>
Turquoise <100>
Cyan <100>
------------- Program x -------------
Dim <255>
Speed <100>
Dim Speed
000 001
- -
255 100
Blue <100>
Lavender <100>
Mauve <100>
Magenta <100>
Pink <100>
Warm White <100>
White <100>
Cold White <100>
001
-
Mode
Auto
100
001
-
Mode
Color Macro
100