Connections, Operating And Display Elements - Cameo CLZW600 Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1 3
1
POWER IN
IP65 power input socket with rubber sealing cap. Operating voltage 100-240 V AC/50-60 Hz. Connection via included power cable (when not
in use, always close with rubber sealing cap).
2
POWER OUT
IP65 power output socket with rubber sealing cap. Facilitates power supply to other CAMEO spotlights. Ensure that the total current
consumption of all connected devices does not exceed the value specified on the device in amperes (A) (when not in use, always close with
the rubber sealing cap).
3
DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console; when not in use, always close with the rubber sealing
cap).
4
DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with the rubber sealing cap).
5
OLED DISPLAY
Displays the current operating mode and other system settings.
6
TOUCH-SENSITIVE CONTROLS
MODE
Press MODE to access the selection menu for system settings. Press repeatedly to go back to the main display.
ENTER
Press ENTER to access the menu levels to make value changes, and to access the sub-menus. Confirm changes by pressing ENTER.
UP and DOWN
Select individual menu items in the selection menu (DMX address, operating mode etc.) and in the sub-menus. Allow changes to the value
of a menu item, such as the DMX address as required.
PRESSURE EQUALISATION ELEMENT
The pressure equalisation element to prevent condensation inside the housing is in the device base, behind the cable feed for the LED unit.
In order to ensure its proper function, the element must be protected from contamination.
HOUSING FAN
The 3 housing fans and the heat sink are on the back of the LED unit. Ensure air circulation by not covering the device, and cleaning it regularly.
6 5 6
4 2
5