Stand Alone - Cameo CLZW600 Bedienungsanleitung

DEVICE SETTINGS (Settings)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN controls, select the menu item "Settings"
(observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode

Stand Alone

Slave
Settings
System Info
This will take you to the sub-menu for configuring the following sub-menu items (select by using UP and DOWN, confirm with ENTER):
Settings
Wireless Setting =
Display Reverse =
Display Backlight =
DMX Fail =
Dimmer Curve =
Dimmer Response =
Color Calibration =
Autolock =
10
W-DMX W-DMX on/off
settings
(wireless DMX)
Operating Mode
Transmitting Mode
Link
Receive Reset
flip display On
Off
display lighting On
Off
operating status Hold
with DMX signal
Blackout
fault
Emergency Light
dimmer curve Linear
Exponential
Logarithmic
S-Curve
dimmer sensitivity LED
Halogen
colour calibration Red, green, blue, white
automatic locking On
of the controls
Off
On = W-DMX enabled
Off = W-DMX disabled
Receive = W-DMX module as receiver
Transmit = W-DMX module as transmitter
G3 = G3 transmission standard
G4S = G4S transmission standard
Link = pair with W-DMX devices. W-DMX must be activated
on all devices and the pairing must be picked up by a trans-
mitter (Receive Reset).
Unlink = unpair all devices
No = do not retain transmitter pairing
Yes = retain transmitter pairing
Rotate display by 180° (e.g. for overhead installation)
No display rotation
Permanent on
Deactivation after approximately 1 minute of inactivity
Last command is retained
Activates blackout
Spotlight changes to colour macro "Cold White"
Light intensity increases linearly with DMX value
Light intensity can be finely adjusted at lower DMX values
and broadly adjusted at higher DMX values.
Light intensity can be broadly adjusted at lower DMX values
and finely adjusted at higher DMX values.
Light intensity can be finely adjusted at lower and higher
DMX values and broadly adjusted at medium DMX values.
Lamp responds abruptly to changes in DMX value
Lamp behaves like a halogen spotlight with slight brightness
changes
Individual colour calibration. Cross-mode brightness setting
of the 4 LED groups RGBW with values 000-255
Automatic locking of the controls after approximately 1
minute of inactivity. After attempted input the display shows:
"Locked!"
Unlock: press and hold UP and DOWN simultaneously for
approx. 5 seconds
Automatic locking of the controls is disabled