Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Sound control
1
Press the button MENU so many times until SOU appears on the display and confirm with ENTER.
2
Use the buttons UP and DOWN to select the number of the desired program (SO01- SO17, SM01).
3
Confirm with the ENTER button.
4
Adjust the microphone sensitivity to the volume of the music with the SENSITIVITY rotary dial.
Master/slave operation with several devices
When several devices are interconnected, the slave units can be synchronized and controlled with the
master unit. The units must be set to the corresponding operating modes.
1
Set all slave units to slave mode: Press the button MENU so many times until SLA appears on the
display. Confirm with the ENTER button.
2
Set all master units to master mode: Press the button MENU so many times until SYS appears on the
display. Confirm with the ENTER button. Under the submenu M-EN, use the buttons UP and DOWN to
set ON. Confirm with the ENTER button.
3
Set the master unit to the desired show program. The interconnected devices will now operate
synchronously.
DMX operation
Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with max. 15 control channels.
However, it can also be switched to a mode with 1, 3, 5, 10 or 15 channels if different functions are required.
To be able to operate the device with a DMX controller, the DMX starting address must be set for the first
DMX channel. The starting address depends upon which DMX controller is being used. Please refer to the
controller's documentation.
1
Press the MENU button so many times until DMX appears on the display. Confirm with the ENTER
button. The display next shows dXXX, please confirm again with ENTER.
2
The display then indicates 1 CH (1 DMX channel), 3 CH (3 DMX channels), 5 CH (5 DMX channels), 10
CH (10 DMX channels) or 15 CH (15 DMX channels). Use the buttons UP and DOWN to select the
desired number of DMX channels. Confirm with the ENTER button.
3
For the DMX start address press the MENU button until dXXX is shown on the display. Use the buttons
UP and DOWN to set the address. Confirm with the ENTER button.
4
The display will not blink when DMX signals are being received. If no control signals are available, the
the display will blink.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
The LEDs of the device are separated into 10 pixels on the main panel, which can be individually controlled
with the following DMX-protocol.
The LEDs of the device are arranged as shown in the graphic below.
7
8
9
1 0
22/28
1
2
3
4
5
6
00114401.DOCX, Version 1.1
Werbung
Inhaltsverzeichnis
