VOLTCRAFT RIM 1000 Bedienungsanleitung Seite 36

• A new measurement will appear automatically in the 5-second
grid. A maximum of 20 measurements will be carried out..
As long as active measurements are recorded by the
measuring device, the bar graph will move at the upper
edge of the LC display.
• With the keys "Ri-Anzeige", "U-Anzeige" and "I-Anzeige", it
is possible during the measurement to select whether the
internal resistance, the voltage or the current is to be dis-
played on the LC display,
• After the 20 measurements, the measuring process is termi-
nated, the moved bars at the top of the LC display will
disappear.
• If the probe tips are removed from the blank after 20 measure-
ments, the display of the last measured value will remain.
Previous removal of the probe tips can unfortunately
not be recognised by the blank but is valued as a
normal measurement!
• If you wish to start a measuring process again, operate the key
"Ri-Anzeige" briefly. Then proceed as described above (se-
lect display unit, carry out measurement).
• If no key is operated on the measuring device, it will switch off
after some time by itself.
• The measuring device has an EEPROM which stores the
settings after the device has been switched off. This means
that the information remains for an almost unlimited period
even without operating voltage. The last measured value,
however, is deleted.
• To switch off, press the "Aus" button briefly.
36