Connecting The Control System - Oase Aquarius Eco Expert 20000/12 V Inbetriebnahme

WARNING
The power supply carries dangerous electrical voltage and must not be placed directly near wa-
ter. Otherwise, there is a risk of serious injury or death from electric shock.
The transformer is subject to dangerous voltage and must not be installed directly adjacent to
the water. Otherwise there is a risk of severe injuries or death by electrocution.
 Install the power supply in a flood-protected position at least 2 m (6.6 ft) from the water.
CAUTION
Rotating components in the area of the intake connection and the pressure connection. Reach-
ing into the connections can lead to injuries.
Please note in particular: If a unit has stopped due to overload, it can start up unexpectedly!
 Do not reach into the opening of the inlet connection or outlet connection while the power
plug is connected.
 If the connections are freely accessible, e.g. if no hoses are connected, secure the connections
with a finger guard. The finger guard is available as an accessory.
NOTE
If the pump is used for conveying excessively muddy water, the impeller unit will be subject to
increased wear and will require earlier replacement.
 Thoroughly clean the pond or pool before installing the pump.
 Install the pump at a raised level above the bottom of the pond. This reduces intake of muddy
water.

Avoid direct sunlight when the components of the unit are not immersed, as this can cause
them to heat up considerably. Use a protective cover if necessary.

Connecting the control system

The control unit OASE Eco Control (accessories) is required to operate the pump.
Alternatively, the pump can be integrated in an OASE Control network. For information on this
topic, visit www.oase.com.

For further information refer to the manual for the accessories.
Connecting and disconnecting the OASE Control plug connection
14
PLX0004