Trimmer Settings; Manner.of.operation; Cutting Grass - FLORABEST FAT 18 B2 Originalbetriebsanleitung

GB

Trimmer settings

To.adjust.the.auxiliary.handle:
The auxiliary handle can be set to various
positions. Adjust the handle such that the
cutting disk slightly tilts forward in your
working position.
Loosen the screw (23) in the handle

and move the auxiliary handle (5) to
your favourite position. Tighten the
screw in the handle.
To.adjust.the.height:
The telescopic shaft allows you to adjust
the appliance to your personal size.
Loosen the threaded bush
‚
(8). Adjust the telescopic shaft (9)
to the correct length and tighten the
threaded bush.
To.adjust.the.cutting.angle:
Changing the cutting angle lets you trim
grass at places that a difficult to reach,
e.g. under benches or wall offsets.
Tread on the pedal (15) on the motor
ƒ
housing and tilt the telescopic shaft
(9). There are 4 preset tilt angles (see
"Work instructions").
To.adjust.the.handle.rod:
The handle rod can be turned by 90° and
180° (see "Work instructions").
Push down the lock (7) and turn the
„
handle rod
snaps into your favourite position.
50
0° 90° 180°
(6) until it
To.adjust.the.spacer.bow.(flower.
guard):
The spacer bow keeps the trimming as-
sembly away from plants and trunks not to
be cut.
Push the spacer bow (11) forward.
…
When the spacer bow is not in use you
can move it back to its parking posi-
tion.
Manner of operation
WARNING..Danger.of.in-
jury!
.
• Do not cut moist or wet grass.
• Prior to starting the appliance,
check that the cutting disk does
not contact stones, gravel or other
foreign bodies.
• Switch on the trimmer before you
approach the grass that is to be
cut.
• Do not overload the trimmer dur-
ing operation.
• Avoid contact with obstacles
(stones, walls, fences, etc.) as this
will rapidly wear out the lines.
.

Cutting grass

series of levels from top to bottom.
Cut the grass by
swaying the trimmer
sideways to the right
and left. Cut slowly
while the trimmer is
tilted forwards by
approx. 30°.
Cut tall grass by a