Scope Of Delivery; Symbols Used; Warning Symbols; Other Symbols - Maico WRG 35 Montage- Und Betriebsanleitung

WRG 35 Decentralised
heat recovery unit

1. Scope of delivery

WRG 35 SR Building shell set
(Article no. 0192.0450)
● Wall sleeve (3-part)
● Plaster protective cover, 2 pieces
● Polystyrene support with surface for a
spirit level
● Installation and Operating Instructions
● Stainless steel external cover with
4 cover plugs
● Drilling template
WRG 35 SR Final installation set
(Article no. 0082.0233)
● Complete fan unit, consisting of 2 housing
shells, 2 fans, 2 electrically operated
shutters, 2 fly screens, 2 G4 air filters as
well as 1 plate heat exchanger, 1 control
circuit board and 1 pluggable terminal block
for the power connection.
● Internal cover
● Foam seal
● Installation and Operating Instructions
Room air control
● Surface-mounted: RLS 4 AP Room air
control (Article no. 0157.0843)
● Modular ribbon cable with RJ12 Western
plug, ready-made
or
● Recessed-mounted: RLS 4 UP room air
control (Article no. 0157.0844)
● Modular ribbon cable with RJ12 Western
plug, ready-made
Imprint: © Maico Elektroapparate-Fabrik GmbH.
This instruction is a translation of the German
original operating instructions. We are not respon-
sible for mistakes or printing errors and retain the
right to make technical modifications without giving
prior notice.

2. Symbols used

2.1 Warning symbols

Danger to life.
Non-observance can lead to
death or serious bodily injuries.
DANGER
Danger of injury.
Non-observance can lead to
serious bodily injuries
WARNING
Property damage.
NOTICE
Non-observance can lead to
damage to property.

2.2 Other symbols

INFO symbol: Text passages
i
marked with this symbol contain
important information and tips.
●
List symbol: List with important
information about the corres-
ponding subject.

Action symbol: List of work
to be carried out. Follow the
instructions given in the order
stated.

3. Product information

This ventilation unit with heat recovery is
used for controlled ventilation and air
extraction of individual rooms.
Used air is transported to the outside and
heat is extracted from it at the same time.
During this process, more than 70 % of the
exhaust air heat is recovered.
Wall sleeve (Building shell set WRG 35 SR)
is inserted during the building phase in an
external wall along with the installation of the
external cover. The wall sleeve is protected
by both plaster protective covers.
The fan unit is installed with the internal cover
and the electrical connection is made, after
the plastering and painting work is completed
(Final installation set WRG 35 SE).
The unit is operated through the separate
RLS 4 AP or RLS 4 UP room air control.
21