Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WARNING!
To avoid electric shock, disconnect all leads from any equipment
before you remove or install the battery.
Follow these steps to install the battery.
1. Disconnect all test leads.
2. Set the Rotary Selector Switch to the - position.
3. Remove the four screws to open the back cover.
4. Place the battery inside
5. Replace the meter's back cover and secure it with the screws.
WARNING!
Do not discard the provided battery insulation capsule. If you do not
use this insulation capsule properly, it might cause damage or
injury.
WARNING!
Do not operate the meter until you replace the battery and close the
battery compartment cover.
Statutory Notification about the Battery Regulations
The delivery of many devices includes batteries, which for example
serve to operate the remote control. There also could be batteries
or accumulators built into the device itself. In connection with the
sale of these batteries or accumulators, we are obliged under the
Battery Regulations to notify our customers of the following:
-27-
Werbung
Inhaltsverzeichnis
