PeakTech 3260 Bedienungsanleitung Seite 26

Note:
Disconnect power from any resistor or circuit to be measured before
measuring resistance. Do not apply any power before the
measurements are completed and the test leads are disconnected.
6. Connect the test leads across the resistance which is to be
measured. If there is a "forward" and "backward" resistance,
such as with rectifiers and diodes, observe polarity in the lead
connections to control each direction of test.
7. Read the indication on the OHMS scale at the top of the dial.
Note that the arc reads from right to left for increasing values.
8. Multiply the reading by the multiplier factor indicated at the
switch position: the result is the resistance value in ohms. "K"
on the dial stands for "thousand".
CAUTION!
Never connect the test leads directly across any source of voltage
when used for current measurements. This will damage the
instrument.
4.4. Measuring Direct- and Alternating Current
CAUTION!
Never connect the test leads directly across any source of voltage
when the instrument is used for current measurements. This will
damage the instrument.
1. Connect the black test lead in the COM - jack, and the red test
lead in the AmV jack.
2. Set the range switch for the appropriate milliampere range (up
to 1000 mA).
-25-