Safety Instructions - Ferm AGM1081 Originalbetriebsanleitung

2. SAFETY INSTRUCTIONS

In this manual and/or on the machine the
following symbols are used:
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-
observance of the instructions in this
manual.
Indicates electrical shock hazard.
Risk of fire
Use spindle lock only in stand still mode.
Keep bystanders away
Wear ear and eye protection
Wear protective gloves
Special safety instructions
• C heck that the maximum speed indicated on
the grinding disc corresponds to the maximum
speed of the machine. The speed of the
machine must not exceed the value on the
grinding disc.
• M ake sure that the dimensions of the grinding
disc correspond to the specifications of the
machine.
• M ake sure that the grinding disc has been
mounted and fastened properly. Do not
use reducing rings or adapters to make the
grinding disc fit properly.
• T reat and store grinding discs in conformance
with the supplier's instructions.
• D o not use the machine for grinding
workpieces with a maximum thickness
exceeding the maximum grinding depth of the
grinding disc.
• D o not use grinding discs for deburring.
• W hen grinding discs have to be mounted on
6
the thread of the spindle, make sure that the
spindle has sufficient thread. Make sure that
the spindle is sufficiently protected and does
not touch the grinding surface.
• B efore use, inspect the grinding disc for any
damage. Do not use grinding discs which are
crack-ed, ripped or otherwise damaged.
• B efore use, let the machine run idle for 30
seconds. Immediately switch off the machine
in case of abnormal vibrations or occurrence
of another defect. Carefully inspect the
machine and grinding disc before switching
the machine on again.
• M ake sure that sparks do not put people into
danger or that they contact highly flammable
substances.
• M ake sure that the workpiece is sufficiently
supported or clamped. Keep your hands away
from the surface to be cut.
• A lways wear safety goggles and hearing
protection. If desired or required also use
another kind of protection like for example an
apron or helmet.
• E nsure that mounted wheels and points are
fitted in accordance with the manufacturer's
instructions.
• E nsure that blotters are used when they are
provided with the bonded abrasive product
and when they are required.
• I f a guard is supplied with the tool never use
the tool without such a guard.
• F or tools intended to be fitted with threaded
hole wheel, ensure that the thread in the wheel
is long enough to accept the spindle length.
• E nsure that ventilation openings are kept
clear when working in dusty conditions. If it
should become nessesary to clear dust, first
disconnect the tool from the mains supply
(use non metallic objects) and avoid damaging
internal parts.
• T hough poor conditions of the electrical
mains, shortly voltage drops can appear when
starting the equipment. This can influence
other equipment (eq. blinking of a lamp). If
the mains-impedance Zmax <0.348 Ohm,
such disturbances are not expected. (In case
of need, you may contact your local supply
authority for further information.