Trouble Shooting; Fault Correction - FLORABEST FHE 710 A1 Betriebsanleitung

Trouble shooting

Problem
Device does not
start
Inferior cutting
performance
Saw runs with
difficulty, chain
(1 ) comes
off
Chain (
1) becomes
hot, smoke
development
during sawing,
discoloration of
the rail
Telescopic han-
dle cannot be
locked
Possible cause
Mains voltage defective
House protection fuse activated
Defective On/Off switch (
10)
Worn carbon brushes
Defective motor
Incorrectly mounted saw chain
( 1)
Saw chain ( 1) blunt
Chain tension insufficient
Chain tension insufficient
Too little chain oil
Allen screw ( 17b) loose on
the quick release (

Fault correction

Check plug socket, cable, line and
plug, where appropriate, repair by
electrical specialist.
Check house protection fuse, see note
Repair by customer service
Repair by customer service
Repair by customer service
Mount saw chain correctly
Sharpen cutting teeth or place on
new chain
Check chain tension
Check chain tension
Check oil level and, where appro-
priate, refill with chain oil,
check oil automatic system and,
where appropriate, clean oil outlet
channel (
by customer service
Check fine-tuning for lubrication
system (oil regulation button).
Tighten Allen screw
17)
GB IE
22 or have repaired
CY
21