Scope Of Delivery; Device Description; General Information - Benning MM P3 Bedienungsanleitung

- the device was exposed to extraordinary stress during transport.
In order to prevent danger

- do not touch the bare measuring probe tips of the measuring
lines
3.

Scope of delivery

The scope of delivery of the BENNING MM P3 comprises:
3.1 One BENNING MM P3, with firmly connected attached safety measuring
lines, black and red (L = 0.6 m, tip Ø 2 mm)
3.2 One protective case,
3.3 Two 1.5 V (LR44) batteries are integrated into the device,
3.4 One operating manual.
Parts subject to wear:
- The BENNING MM P3 is supplied by means of two integrated 1.5 V batteries
(LR44).
4.

Device description

See figure 1: Device front
The display and operating elements shown in figure 1 are designated as follows:
 Digital display, displaying measured value and range exceedance,
 Polarity indication,
 Battery indication, appears in case of discharged battery,
4 HOLD key, storage of the displayed measured value,
5 SELECT key for selecting the secondary or tertiary function,
6 RANGE key, switch-over between automatic/ manual measuring range,
7 Rotary switch, for selecting the measuring function,
8 Safety measuring line (red), positive
9 COM safety measuring line (black), common connection for voltage/ resistance/
frequency/ pulse duty factor/ capacity measurements, continuity and diode
tests,
) This is what the automatic polarity indication for DC voltage refers to
1
5.

General information

5.1 General information on the multimeter
5.1.1 The digital display  is a 3
a decimal point. The highest numerical value to be displayed is 5000.
5.1.2 The polarity indication  works automatically. Only a polarity contrary to the
connection definition is indicated with "-".
5.1.3 The range exceedance is indicated by " 0L" or "- 0L" and partly by an acoustic
warning.
Attention, no indication and warning in case of overload!
5.1.4 Measured value storage „HOLD": Press the "HOLD" key 4 to store the
measuring result. At the same time, the display shows the "HOLD" symbol.
12/ 2007
connection for V, Ω,
1
/ -digit LC display with a font size of 14 mm and
5
6
BENNING MM P3

, Hz,
21