Taking Into Operation - Truma SecuMotion Gebrauchsanweisung Und Einbauanweisung

Taking into operation

Open gas remote switch if
present.
2.
1.
3 sec
1. Open the cylinder's valve.
2. Firmly press the hose rupture
protection device (green button)
on the high pressure hose.
3. Press gas flow monitor reset
button (green button) on gas
pressure regulation system
slowly.
4. Release gas flow monitor
reset button (green button) on
gas pressure regulation system
slowly (3 seconds).
If no pressure point is felt when
the button is pressed again, the
gas pressure regulation system
3.
is ready for operation (repeat
procedure if necessary).
4.
Start the gas-burning devices if
desired.
If the gas cylinders are closed,
SecuMotion may switch off after
an extended period of no usage.
Changing a gas cylinder
Please use the included screwing
tool to attach and remove the high
pressure hoses. It will help you
generate the necessary tightening
torque and will prevent damage
to the screw fittings, which may
otherwise result from using an
improper tool.
Residual gas: No smoking!
No open flames!
– Close the empty gas cylinder's
valve.
– Unscrew the high pressure
hose from the gas cylinder
and remove the clip-on adapt-
er, if present.
– Screw the high pressure hose
to the full gas cylinder and apply
the clip-on adapter, if present.
– Open the full cylinder's valve.
13