Yamaha YSP-4000 Bedienungsanleitung Seite 88

MANUAL SETUP
INPUT RENAME (Input rename)
Use to change the name of the input source in the OSD
and the front panel display. Press an input selector button
(e.g., DVD) to select the component you want to change
the name for and perform the following procedure.
D)INPUT RENAME
DVD ->
p
[ ]/[ ]:Position
[ ]/[ ]:Character
[ENTER]:Return
1
Press / to place the _ (underscore) under
the space or the character you want to edit.
The _ (underscore) flashes.
2
Press / to select the desired character.
• You can use up to 8 characters for each input.
• Press to change the character in the following
order or press
A to Z, a space, 0 to 9, a space, a to z, a space, #, *,
+, etc.
3
Repeat steps 1 to 2 to rename each input.
4
Press ENTER to exit.
The new names are registered, and the display returns
to the previous screen.
86
En
DVD
ENTER
to go in the reverse order:
ENTER
ENTER
HDMI SET (HDMI settings)
Use to change the HDMI audio/video output/input to
match the connected component.
Choices: SUPPORT AUDIO (Support audio),
VIDEO INFO (Video information),
UP-SCALING (HDMI up-scaling),
ASPECT RATIO (HDMI aspect ratio),
HDMI CONTROL (HDMI control)
E)HDMI SET
.
a)SUPPORT AUDIO
b)VIDEO INFO
c)UP-SCALING
d)ASPECT RATIO
e)HDMI CONTROL
[ ]/[ ]:Up/Down
[ENTER]:Enter
SUPPORT AUDIO (Support audio)
Use to select whether to play back HDMI audio signals on
this unit or on another HDMI component connected to the
HDMI OUT jack of this unit.
Choices: YSP-4000, OTHER
a)SUPPORT AUDIO
p
YSP-4000
p
[ ]/[ ]:Select
[ENTER]:Return
Notes
• This setting is effective when HDMI CONTROL is set to OFF
(see page 87).
• The HDMI video signals input at one of the HDMI IN jacks of
this unit are always output at the HDMI OUT jack of this unit.
• When HDMI CONTROL is set to ON, this setting is ineffective.
This unit follows the setting of the HDMI control-compatible
TV.
OTHER