Dmx Operation - EuroLite LED UMBRELLA 95 Bedienungsanleitung

Sound control
Via the integrated microphone the unit can perfectly reproduce the show programs to the rhythm of the
music (sufficient bass provided).
1 Press the MENU button so many times until SOUD is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program. Confirm with the ENTER
button.
Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
Configure all slave units before connecting the master unit: Set the desired master mode SOUD or AUTO -
for the master device, as described above. Set the DMX mode for all slave devices.
1 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
2 Set the master unit to the desired operating mode. The interconnected devices will now operate
synchronically.

DMX operation

Setting the number of DMX channels and the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 24 control channels.
However, it can also be switched to a mode with 6 channels if different functions are required. To be able to
operate the device with a DMX controller, the DMX starting address must be set for the first DMX channel.
The starting address depends upon which DMX controller is being used. Please refer to the controller's
documentation.
1 Press the MENU button so many times until PERS is indicated in the display. Confirm with the ENTER
button.
2 The display indicates 6 CH (6 DMX channels) or 24 CH (24 DMX channels). Use the buttons UP and
DOWN to select the desired number of DMX channels. Confirm with the ENTER button.
3 Press the MENU button so many times until dMX is indicated in the display. Confirm with the ENTER
button.
4 Now the display indicates the menu item for the DMX start address d.***. Use the buttons UP and
DOWN to set the address. Confirm with the ENTER button.
5 A dot will blink when DMX signals are being received. If no control signals are available, the dot will not
blink.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed
similarly, they will work synchronically.
Functions in DMX mode
Mode/ DMX
Channel value
6 CH 24 CH
1 1
0 255
2 2
0
10 255
Dimmer intensity
F Gradual adjustment of the dimmer intensity from 0 to 100 %
Strobe
9 S No function
F Strobe-effect with increasing speed
Feature
23/28 00117302.DOCX, Version 1.1