Operation; Menu Structure; Stand-Alone Mode - EuroLite LED UMBRELLA 95 Bedienungsanleitung

OPERATION

After connecting the device to the mains it is ready for operation. The display indicates the last operating
mode. The operating modes can be selected by means of the display and the control buttons. All settings
remain stored even if the device is disconnected from the mains. The device can be operated in stand-alone
mode via the control board or in DMX-controlled mode via any commercial DMX controller.

Menu structure

The main menu is accessed by pressing Menu until the display is lit. Browse through the menu by pressing
Menu. Press Enter in order to select the desired menu. You can change the selection by pressing Up or
Down. Press Enter in order to confirm. You can leave every mode by pressing Menu. The functions provided
are described in the following sections.
Mode
Individual color mix /
strobe effect
Automatic mode
Running speed in
automatic mode
Sound control
DMX mode

Stand-alone mode

Individual color mix / strobe effect
In the color mode STAT each of the tricolor LEDs can be individually adjusted for brightness. The device will
constantly emit the color adjusted.
1 Press the MENU so many times until STAT is indicated in the display. Confirm with the ENTER button.
2 Now the display indicates the letter R for the color red and the corresponding brightness value. Use the
buttons UP and DOWN to adjust the desired brightness.
3 Confirm with the ENTER button. Now the color green can be adjusted; then blue.
4 Confirm with the ENTER button. The display will show ST. Use the buttons UP and DOWN to adjust the
desired strobe speed (ST.00 = slow, ST.20 = fast). Confirm with the ENTER button.
Automatic mode
In automatic mode, 52 show programs are available that run at an adjustable speed.
1 Press the MENU button so many times until AUTO is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to select the desired show program (AT.01 - AT.52). Confirm
with the ENTER button.
2 Press the MENU button so many times until SP.xx is indicated in the display. Confirm with the ENTER
button. Use the buttons UP and DOWN to adjust the running speed of the program from SP.01 (slow) to
SP.20 (fast). Confirm with the ENTER button.
Display
R.xxx
G.xxx
STAT
b.xxx
ST.xx
AT.xx
AUTO
SP.xx
MOD1
SOUD
MOD2
dMX d.xxx
6CH.
PERS
24CH.
22/28
R.000-255 Red 0-100%
G.000-255 Green 0-100%
b.000-255 Blue 0-100%
Strobe effect
ST.00-20
slow to fast
AT.01-52 Program 1 - 52
Program running speed
SP.01-20
slow to fast
Program 1
Program 2
d001-512
Starting address
6-channel mode
24-channel mode
00117302.DOCX, Version 1.1
Function